If you want to make a double folded bias tape you will need to cut your strips with a 2 width. Diy easy bias tape double fold detail steps.
Cut a continuous strip of bias tape from one square of fabric youll need a 8 12 inch square to make approximately 29 inches of a 2 inch wide bias strip.
How to make bias tape easy.
Mark with chalk with the help of ruler.
Here is a basic calculation and you can adjust for your needs.
Open your bias tape and place the top edge against the raw edge of your fabric.
This method of making your own bias tape is great when you need just a little bit.
How to sew bias tape stay stitch 14 away from the raw edge to prevent the fabric from stretching as you work with it.
Match up the selvage edge with the 45 degree marking on your ruler.
Step 2 joining the bias strips together.
Take square fabric eg.
Lay out your fabric flat.
Maybe you just need enough tape to finish off a neckline to use as armhole bindings.
I always pin mine just didnt put a pin in the photo.
Fold square fabric in diagonal direction and make it rectangle way mention below.
That depends on how wide you need your bias tape.
Youll need a 14 12 inch square to make approximately 94 inches of a 2 inch wide bias strip.
Give one final press so everything stays nice and flat together.
On your pressing board or ironing board insert long quilting pins so that you can slide the fabric strips through easily.
Place the bias strips right sides together at a right angle with the top left corner of one edge matching the bottom right corner.
Continue moving the bias tape maker down the strip of fabric pressing as you go until you reach the other end.
Sew the fabric to your bias tape using a straight stitch inside the crease of your bias tape.
You will end up with one long strip of fabric.
This is the most popular bias tape on the market and it can be used in a lot of sewing projects.
With bias tape you will have more room for thicker fabrics.
Using a 1 bias tape maker take one end of your tape and feed it wrong side facing up into the wide end.
Step 4 making double folded bias tape.
How much width you want i am taking 1inch so the end double fold bias tape would be 025inch.
The easiest way to make bias tape.
Youll need a 20 12 inch square to make.
10 x 10 inch.
You can use it for binding for piping or to decorate your crafts.
Most yardage is around 40 wide of usable fabric so with the seam on the vertical you will get approximately 1 yard of bias tape for each cut.
Step 3 making single fold bias tape.
Finally fold the pressed edges together to make your double fold binding tape.
Step 1 cutting the bias strips.
Instructions on how to make bias tape.
Now you are ready to begin making your bias tape.
Pin the pieces together and line up the raw edge with the 58 seam guide on your sewing machine.
Do this if you need say less than a yard of bias.
No comments:
Post a Comment